Tools required
Versana Balance – Basic Service Manual System view 10-7
5808768-100 English Rev.9
10-5 Tools required
NOTE: For a list of required tools for servicing the Versana Balance,
refer to chapter 8.
10-5-1 Standard GE tool kit
The following is a description of the “Standard” GE tool kit in the
USA. Not all tools are required.
Table 10-2: Overview of GE-1 tool kit contents
Tool ID Description Tool ID Description
9-45358 Pliers Retaining Ring 9-XL9971MM Xcelite-hex Blade 1.27mm
9-4078 Scribe 9-XL9972MM Xcelite-hex Blade 1.5mm
9-44572 Wrench Open End 3/8 - 7/16 9-XL9973MM Xcelite-hex Blade 2 mm
9-44579 Wrench Open End 1/2 - 9/16 9-XL9974MM Xcelite-hex Blade 2.5mm
9-44579 Wrench Open End 1/2 - 9/16 9-XL9975MM Xcelite-hex Blade 3mm
9-45385 Pliers, Arc Joint 7 inch 9-XL9976MM Xcelite-hex Blade 4mm
9-45378 Pliers, Slip Joint 9-XL9977MM Xcelite-hex Blade 5mm
9-4518 Pliers, Long Nose, Miniature 9-XL991CM Handle
9-4518 Pliers, Long Nose, Miniature C2356E Screw starter - Kedman Quick
Wedge
9-44776 Ignition Wrench Set, 10 pc. BLBO Box - 18 Compartment
9-44601 Wrench, Adj., 4 inch DWL4283T Box - 5 Compartment
9-4151 Screwdriver, Blade, Stubby 9-41322 Pickup Tool, Claw type
9-41421 Screwdriver, Blade, Pocket clip 9-6757 6 pc Needle File Set
9-41594 Screwdriver, Blade 1/8 in. × 4 in. 9-9487 Utility Knife
9-41581 Screwdriver, Blade 3/16 in. × 4 in. 9-45341 Pliers Vice Grip 10 inch
9-39451 20' Steel Tape, locking Spring load 9-3001 Xacto Pen Knife
9-GH807 Ratchet, Offset, Slotted 9-HT62002 Solder Aid, Fork and Hook
68-412 Ratchet, Offset, Phillips 9-4099 Mirror, Round, Telescoping
To Next Page
Loading...
Need help?
General
