To Enter Programmin
g Commands
Refer to the HP 8590 E-Series and L-Series Spectrum Analyzer and HP 8591C Cable TV
Analyzer Programmer’s
hide
for more information.
1. Press
cF8_1
on the external keyboard to enter the mode for executing remote commands.
2. Type in a programming command (for example, type IP).
3. Press
[ENTER_)
on the external keyboard to execute the command.
Note
Unlike entering a remote programming command using an external controller,
entering the remote programming commands with the external keyboard does
not require including the spectrum analyzer address. It is also not necessary to
terminate the programming line with a semicolon. However, semicolons are
necessary for separating the programming commands. For example, a program
line is entered via the external controller as: OUTPUT 718;
"CF
300MHZ; SP
1MHZ;
‘I.
The same program line is entered using the external keyboard as:
CF 300MHZ;SP
lMHZ;[ENTERj.
After
IF8)
is pressed, the spectrum analyzer remains in command mode. To return to the title
entry mode, press
m
(on the external keyboard).
To Enter a Prefix
Refer to the HP 8590 E-Series and L-Series Spectrum Analyzer and HP
8591C
Cable TV
Analyzer Programmer’s Guide for more information.
1. Press
IF7]
on the external keyboard to enter the mode for entering a prefix.
2. Type in the prefix.
3. Press
[ENTER]
on the external keyboard.
Using Analyzer Features
5.43
To Next Page
Loading...
Need help?
General
