I
-
I
-
Using Instrument Functions
Saving and Recalling Measurement Results
To
Recall
from
a
Disk
or
Internal
Memory
The network analyzer allows you to recall and display measurement
results that you saved as STATE
hles.
You can then compare the recalled
measurements to subsequent measurements. The analyzer can display
both a data and memory trace for each measurement channel. The data
trace is saved when you select Data
iITs
in the
I&fine
Save menu. The
memory trace is saved as part of the instrument state. These traces will be
automatically redisplayed when you recall the Ele from a disk or internal
memory.
Calibration sets are linked to the instrument state and measurement
parameter for which the calibration was done. Therefore a saved calibration
can be used for multiple instrument states as long as the measurement
parameter, frequency range, and number of points are the same.
1.
Press [SAVE RECALL)
Selec%
pisk
and press the key that corresponds to
the location where your desired file exists.
2. If necessary, change directories to the directory that contains the desired
Ele
as described in “lb Use Directory Utilities” in the next section.
2.
Press
Prior
He&u
and turn the front panel knob to move the highlighted
bar to the
Ille
you want to recall.
4. Press
%~al’L
SW&X
to recall the desired
file
to the network analyzer.
NOTE
Refer to “Measurement Setup and Control with Fast Recall” in Chapter 7 for information on using the
analyzer’s fast recall feature to quickly recall often-used instrument states.
4-68
I-
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
