I
-
I
-
Making Measurements
Making a Power Measurement using Broadband Detection
View
and
Interpret
the
Power
Measurement
Results
1.
To view the measurement trace, press
(ml
htascale
.
2. Figure 3-12 shows the results of an example power measurement.
3. To interpret the power measurement, refer to Figure 3-12 or your
analyzer’s display if you are making this measurement on your
instrument.
a. When making a power measurement, the display shows the output
power measured at the analyzer’s RF IN connector. This power is
absolute power, as opposed to a power ratio.
b. Note that when making a power measurement, the values associated
with the vertical axis are in units of
dBm,
which is the power measured
in reference to 1
mW.
OdBm
=
1mW
-10
dBm
= 100
PW
+lOdBm =
1OmW
3-33
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
