I
-
Automating Measurements
Automated Measurement Setup and Control
AUTOST
files
When
IBASIC
is used, the measurement control program can be saved as an
AUTOST
file
on the analyzer’s non-volatile RAM disk. When the analyzer’s
power is turned on, it will first check for this file on the non-volatile RAM
disk and then on the 3.5” disk, and if found, load it and run it. This feature
simplilies
the task of turning on an automated test station at the beginning of
a working day, or test session.
7-53
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
