I
-
I
-
Optimizing Measurements
Increasing Sweep Speed
To
Turn
Off
Spur
Avoidance
When spur avoidance is on (preset default is
off),
the analyzer breaks each
sweep into segments. Between sweep segments, the analyzer stops and
changes internal frequencies to move mixing products. Since the analyzer
sweep is not interrupted when this feature is off, turn off spur avoidance to
increase sweep speed.
1.
Press
(MENU]
Spur Avoid Options and look at the Spur Avoid
softkey.
2.
If the
SPIIT
Avaid key is highlighted with a box around it, press the
l&me
key.
F
If Spur Avotd
must
be used In your measurement, set the start frequency as high as possible to obtain
5-8
-1
I-
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
