I
-
I
-
Making Measurements
Making a Power Measurement using Broadband Detection
Enter
the
Measurement
Parameters
Press the following keys on the analyzer:
@TEE=]
(NlEAs]
Power
NOTE
This example measurement uses the default instrument parameters for a power measurement. If your
particular power measurement requires specific parameters
[such
as frequency range, source power
level, number of data points, and sweep time) enter them now
1
I
I
3-31
CAUTION
Damage to your analyzer will occur if the receiver input power exceeds
+23
dBm
or 25 Vdc. The analyzer’s source cannot significantly exceed this
level, however if your DUT has gain, then attenuation on the RF IN port
may be necessary. See “When to Use Attenuation and Amplification in a
Measurement Setup” earlier in this chapter for more information.
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
