To Next Page

To Previous Page

Switch Memory and Configuration

Multiple Configuration Files

TFTP: Copying a Configuration File from a Remote Host

Syntax: copy tftp config < dest-file > < ip-addr > < remote-file > < pc | unix >

This is an addition to the copy tftp command options. Use

this command to download a configuration file from a TFTP

server to the switch.

Note: This command requires an empty memory slot in the

switch. If there are no empty memory slots, the CLI displays

the following message:

Unable to copy configuration to "< filename >".

For more on using TFTP to copy a file from a remote host,

refer to “TFTP: Copying a Configuration File from a Remote

Host” on page A-26.

For example, the following command copies a startup-config file named test-

01.txt from a (UNIX) TFTP server at IP address 10.10.28.14 to the first empty

memory slot in the switch:

ProCurve(config)# copy tftp config test-01 10.10.28.14

test-01.txt unix

Xmodem: Copying a Configuration File to a Serially

Connected Host

Syntax: copy config < filename > xmodem < pc | unix >

This is an addition to the copy < config > xmodem command

options. Use this command to upload a configuration file

from the switch to an Xmodem host.

For more on using Xmodem to copy a file to a serially

connected host, refer to “Xmodem: Copying a Configuration

File to a Serially Connected PC or UNIX Workstation” on

page A-26.

6-40

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve