Troubleshooting
Diagnostic Tools
kill
Terminates all other active sessions.
Traceroute Command
The traceroute command enables you to trace the route from the switch to a
host address.
This command outputs information for each (router) hop between the switch
and the destination address. Note that every time you execute traceroute, it
uses the same default settings unless you specify otherwise for that instance
of the command.
Syntax: traceroute < ip-address >
Lists the IP address of each hop in the route, plus the time in microseconds
for the traceroute packet reply to the switch for each hop.
To halt an ongoing traceroute search, press the [Ctrl] [C] keys.
[minttl < 1-255 >]
For the current instance of traceroute, changes the minimum
number of hops allowed for each probe packet sent along the
route. If minttl is greater than the actual number of hops, then
the output includes only the hops at and above the minttl
threshold. (The hops below the threshold are not listed.) If
minttl matches the actual number of hops, only that hop is
shown in the output. If minttl is less than the actual number
of hops, then all hops are listed. For any instance of tracer-
oute, if you want a minttl value other than the default, you
must specify that value. (Default: 1)
[maxttl < 1-255 >]
For the current instance of traceroute, changes the maximum
number of hops allowed for each probe packet sent along the
route. If the destination address is further from the switch
than maxttl allows, then traceroute lists the IP addresses for
all hops it detects up to the maxttl limit. For any instance of
traceroute, if you want a maxttl value other than the default,
you must specify that value. (Default: 30)
[timeout < 1-120 >]
For the current instance of traceroute, changes the timeout
period the switch waits for each probe of a hop in the route.
For any instance of traceroute, if you want a timeout value
other than the default, you must specify that value. (Default:
5 seconds)
C-61
To Next Page
Loading...
Need help?
General