Time Protocols
TimeP: Viewing, Selecting, and Configuring
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
Command Page
show timep 9-18
[no] timesync 9-20 ff., 9-23
ip timep
dhcp 9-20
manual 9-21
server <ip-addr> 9-21
interval 9-22
no ip timep 9-23
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
Using different show commands, you can display either the full TimeP config-
uration or a combined listing of all TimeP, SNTP, and VLAN IP addresses
configured on the switch.
Syntax: show timep
This command lists both the time synchronization method
(TimeP, SNTP, or None) and the TimeP configuration, even if
SNTP is not the selected time protocol. (If the TimeP Mode is
set to Disabled or DHCP, then the Server field does not appear.)
For example, if you configure the switch with TimeP as the time synchroniza-
tion method, then enable TimeP in DHCP mode with the default poll interval,
show timep lists the following:
Figure 9-13. Example of TimeP Configuration When TimeP Is the Selected Time
Synchronization Method
9-18
To Next Page
Loading...
Need help?
General