Power Over Ethernet (PoE) Operation
PoE Operating Notes
PoE Event Log Messages
PoE operation generates these Event Log messages. You can also configure
the switch to send these messages to a configured debug destination (terminal
device or SyslogD server).
“Informational” PoE Event-Log Messages
Message Meaning
I < MM/DD/YY > < HH:MM:SS > Message header, with severity, date, system time, and
<chassis|ports>
system module type (chassis or ports). For more information
on Event Log operation, including severity indicators, refer
to “Using the Event Log To Identify Problem Sources” on
page C-26
Slot < slot-id > POE usage is below Indicates that POE usage on the module in the indicated slot
configured threshold of < 1 - 99 > %
has decreased below the threshold specified by the last
execution of the power threshold command affecting that
module. This message occurs if, after the last reboot, the
PoE demand on the module exceeded the power threshold
and then later dropped below the threshold value.
port < port-id > applying power to PD A PoE device is connected to the indicated port and
receiving power.
port < port-id > PD detected The switch has detected a PoE device connected to the
indicated port.
Slot <slot-id> software update A module needs to have its PoE firmware updated and the
started on PoE controller
software begins the update process. On ProCurve 8212zl
<controller-id>
switches the controller-id is always “1”
Slot <slot-id> software update A module has its PoE firmware updated and the software
completed on PoE controller
has finished this process.
<controller-id>
11-28
To Next Page
Loading...
Need help?
General