To Next Page

To Previous Page

Configuring for Network Management Applications

LLDP (Link-Layer Discovery Protocol)

delay interval delays the port’s ability to reinitialize and generate LLDP traffic

following an LLDP disable/enable cycle.

Syntax setmib lldpReinitDelay.0 -i < 1 - 10 >

Uses setmib to change the minimum time (reinitialization

delay interval) an LLDP port will wait before reinitializing

after receiving an LLDP disable command followed closely by

a txonly or tx_rx command. The delay interval commences

with execution of the lldp admin-status < port-list > disable

command. (Default: 2 seconds; Range: 1 - 10 seconds)

For example, the following command changes the reinitialization delay

interval to five seconds:

ProCurve(config)# setmib lldpreinitdelay.0 -i 5

Configuring SNMP Notification Support

You can enable SNMP trap notification of LLDP data changes detected on

advertisements received from neighbor devices, and control the interval

between successive notifications of data changes on the same neighbor.

Enabling LLDP Data Change Notification for SNMP Trap Receivers.

Syntax [ no ] lldp enable-notification < port-list >

Enables or disables each port in < port-list > for sending

notification to configured SNMP trap receiver(s) if an LLDP

data change is detected in an advertisement received on the

port from an LLDP neighbor. (Default: Disabled)

For information on configuring trap receivers in the switch,

refer to “SNMPv3 Notification and Traps” on page 14-17.

For example, this command enables SNMP notification on ports 1 - 5:

ProCurve(config)# lldp enable-notification 1-5

14-47

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve