File Transfers
Downloading Switch Software
c. In the Protocol field, select Xmodem.
d. Click on the
[Send] button.
The download can take several minutes, depending on the baud rate used
in the transfer.
3. When the download finishes, you must reboot the switch to implement
the newly downloaded software. To do so, use one of the following
commands:
Syntax:
boot sy
stem flash <primary | seconda
ry>
Reboots from the selected flash.
Syntax:
reload
Reboots from the flash image currently in use.
(For more on these commands, see “Rebooting the Switch” on page 6-19.)
4. To confirm that the software downloaded correctly:
ProCurve> show system
Check the Firmware revision line. It should show the software version that
you downloaded in the preceding steps.
If you need information on primary/secondary flash memory and the boot
commands, refer to “Using Primary and Secondary Flash Image Options” on
page 6-14.
Using USB to Transfer Files to and from the Switch
The switch’s USB port (labeled as Auxiliary Port) allows the use of a USB
flash drive for copying configuration files to and from the switch.
Operating rules and restrictions on USB usage are:
■ Unformatted USB flash drives must first be formatted on a PC (Windows
FAT format). For devices with multiple partitions, only the first partition
is supported. Devices with secure partitions are not supported.
■ If they already exist on the device, sub-directories are supported. When
specifying a <filename>, you must enter either the individual file name (if
at the root) or the full path name (for example, /subdir/filename).
A-18
To Next Page
Loading...
Need help?
General