---- ---------------------------------------- -------- ---------- ----------
Redundancy (Switch 8212zl)
Using Redundant Management
Enabling and Disabling Fabric Modules
The fabric modules can be enabled or disabled even if they are not present in
the switch. You cannot disable both fabric modules at the same time; one must
be enabled. Use this command to enable or disable the resilient fabric
modules. Disabling one fabric module reduces the overall switching capacity
of the 8200zl series switches. On some networks where network utilization is
less than 50%, you may not notice any degradation of performance.
Note A single fabric module connects to all 12 module slots.
Syntax: redundancy fabric-module [1 | 2] [enable | disable]
Allows enabling or disabling of fabric modules. You cannot
have both fabric modules disabled at the same time.
Default: Both fabric modules are enabled.
ProCurve(config)# redundancy fabric-module 2 disable
ProCurve(config)# show redundancy
Settings
--------
Mgmt Redundancy : enabled
Statistics
----------
Failovers : 0
Last Failover :
Slot Module Description Status SW Version Boot Image
MM1 ProCurve J9092A Management Module 8200zl Active K.12.30 Primary
MM2 ProCurve J9092A Management Module 8200zl Standby K.12.30 Primary
FM1 ProCurve J9093A Fabric Module 8200zl Enabled
FM2 ProCurve J9093A Fabric Module 8200zl Disabled
Figure 15-7. Example of Disabling a Fabric Module
15-12
To Next Page
Loading...
Need help?
General