To Next Page

To Previous Page

Port Status and Configuration

Viewing Port Status and Configuring Port Parameters

Viewing Port Utilization Statistics

Use the show interface port-utilization command to view a real-time rate display

for all ports on the switch. The following shows a sample output from this

command.

ProCurve(config)# show interfaces port-utilization

Status and Counters - Port Utilization

Rx Tx

Port Mode | --------------------------- | ---------------------------

| Kbits/sec Pkts/sec Util | Kbits/sec Pkts/sec Util

--------- -------- + ---------- ---------- ----- + ---------- ---------- -----

B1 1000FDx | 0 0 0 | 0 0 0

B2 1000FDx | 0 0 0 | 0 0 0

B3 1000FDx | 0 0 0 | 0 0 0

B4 1000FDx | 0 0 0 | 0 0 0

B5 1000FDx | 0 0 0 | 0 0 0

B6 1000FDx | 0 0 0 | 0 0 0

B7 100FDx | 624 86 00.62 | 496 0 00.49

Figure 10-5. Example of a Show Interface Port-Utilization Command Listing

Operating Notes:

■ For each port on the switch, the command provides a real-time display

of the rate at which data is received (Rx) and transmitted (Tx) in terms

of kilobits per second (KBits/s), number of packets per second (Pkts/

s), and utilization (Util) expressed as a percentage of the total band-

width available.

■ The show interfaces <port-list> command can be used to display the

current link status and the port rate average over a 5 minute period.

Port rates are shown in bits per second (bps) for ports up to 1 Gigabit;

for 10 Gigabit ports, port rates are shown in kilobits per second

(Kbps).

Viewing Transceiver Status

The show tech transceivers command allows you to:

■ Remotely identify transceiver type and revision number without having

to physically remove an installed transceiver from its slot.

■ Display real-time status information about all installed transceivers,

including non-operational transceivers.

10-9

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve