HP ProCurve Management And Configuration Guide

Using the Menu Interface
Starting and Ending a Menu Session
Figure 3-1. Example of the Main Menu with Manager Privileges
For a description of Main Menu features, see “Main Menu Features” on page
3-7.
Note To configure the switch to start with the menu interface instead of the CLI, go
to the Manager level prompt in the CLI, enter the
setup command, and in the
resulting display, change the
Logon Default parameter to Menu. For more infor-
mation, see the Installation and Getting Started Guide you received with the
switch.
How To End a Menu Session and Exit from the Console:
The method for ending a menu session and exiting from the console depends
on whether, during the session, you made any changes to the switch configu-
ration that require a switch reboot to activate. (Most changes via the menu
interface need only a S
ave, and do not require a switch reboot.) Configuration
changes needing a reboot are marked with an asterisk (*) next to the config-
ured item in the menu and also next to the Switch Configuration item in the
Main Menu.
3-5

HP ProCurve Specifications

General

Brand	HP
Model	ProCurve
Category	Switch
Language	English