HP ProCurve Management And Configuration Guide

Monitoring Resources
Viewing Information on Resource Usage
Resource usage by the following features, which are configured globally or
per-VLAN, applies across all slots with installed modules:
■ ACLs
■ QoS configurations
■ Management VLAN configuration
■ DHCP snooping
■ Dynamic ARP protection
■ Remote-mirroring endpoint configuration
Resource usage on the following features, which are configured per-port,
applies only to the slot or port group on which the feature is configured:
■ ACLs applied per-port through RADIUS authentication
■ ACLs applied per-port through the CLI using the ip access-group and
monitor ip commands.
■ ICMP rate-limiting
■ Virus throttling applied to any port (when a high connection-rate client is
being throttled or blocked)
Displaying Current Resource Usage
To display current resource usage in the switch, enter the show resources
command.
Syntax: show <qos | access-list> resources
Displays the resource usage of the Policy Enforcement Engine on the
switch by software feature. For each type of resource, the amount still
available and the amount used by each software feature is shown.
The qos and access-list parameters display the same command output.
The show resources command output allows you to view and re-prioritize
current resource usage and, if necessary, reconfigure software features to free
resources reserved for less important features.
Note A 1:1 mapping of internal rules to configured policies in the switch does not
necessarily exist. As a result, displaying current resource usage is the most
reliable method for keeping track of available resources. Also, because some
internal resources are used by multiple features, deleting a feature configura-
tion may not increase the amount of available resources.
E-3

HP ProCurve Specifications

General

Brand	HP
Model	ProCurve
Category	Switch
Language	English