To Next Page

To Previous Page

File Transfers

Downloading Switch Software

Syntax: no tftp-enable

This command disables all TFTP operation on the switch except

for the auto-TFTP

feature. To re-enable TFTP operation, use the tftp-enable command. When TFTP is

disabled, the instances of tftp in the CLI copy command and the Menu interface

“Download OS” screen become unavailable.

Note: This command does not disable auto-TFTP operation. To disable an auto-

TFTP command configured on the switch, use the no auto-tftp command described

below to remove the command entry from the switch’s configuration.

Syntax: no auto-tftp

If auto-TFTP is configured on the switch, this command deletes the auto-tftp entry

from the switch configuration, thus preventing auto-tftp operation if the switch

reboots.

Note: This command does not affect the current TFTP-enable configuration on the

switch.

Command Options

If you need to enable SSH v2 (which is required for SFTP) enter this command:

ProCurve(config)# ip ssh version 2

Note As a matter of policy, administrators should not enable the SSHv1-only or the

SSHv1-or-v2 advertisement modes. SSHv1 is supported on only some legacy

switches (such as the ProCurve Series 2500 switches).

To confirm that SSH is enabled type in the command

ProCurve(config)# show ip ssh

Once you have confirmed that you have enabled an SSH session (with the show

ip ssh command) you can then open your third-party software client applica-

tion to begin using the SCP or SFTP commands to safely transfer files or issue

commands to the switch.

If you need to disable secure file transfer:

ProCurve(config)# no ip ssh filetransfer

A-13

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve