17
ENGLISH
(3) Temporarily stopping the sewing machine
■
How to stop the sewing machine
1) Press temporary stop switch
.
2)
The sewing machine stops and “Er 10” is displayed.
■
How to re-start
1) Press [RESET ] key
while “Er 10” is being
displayed and the error is released.
2) Re-start the sewing machine using the start switch,
or press [FORWARD ] key
or [BACK ]
key
and the feed mechanism travels forward/
backward stitch by stitch.
Further, press [RESET ] key
to return the
sewing machine to the sewing start position.
Operation of [FORWARD ] key,
[BACK ] key or [RESET ] key cannot
perform thread trimming.
When temporarily stopping the sewing machine
during sewing and returning the sewing
machine to the start position with [RESET ]
key, draw out needle thread, cut the thread
with scissors or the like and perform the work.
The work can be performed without applying a
forced load to needle or sewing product.
Sewing can be performed without making the cloth open operation.
1) Make sure that sewing LED
goes out.
When the LED lights up, press [READY ] key
to make it go out.
2) Press [OPEN ] key
to light up cloth open
LED
.
3) Press [READY ] key
to perform the origin
retrievel and the right and left presser plates
open. The cloth setting position becomes the
knife actuating position.
4) The sewing can be performed with the presser
switch and the start switch.
Cloth open ON/OFF operation is not performed.
5)
To release this setting, press [READY ] key
to make the sewing LED go out, then press [OPEN
] key
to make cloth open LED
go out.
When the cloth cutting knife is not operated,
prohibit the knife operation with [KNIFE ON/
OFF
] key
.
(4) Performing re-sewing
To Next Page
Loading...
Need help?
General
