50
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
A
B
0 to 0.5 mm
Adjust the clearance between the presser
foot and the holding plate to 0 to 0.5 mm.
Loosen two setscrews
in the presser arm base
and the adjust the clearance. Then fix the presser
arm in place.
Moving presser arm
in the direction A will
reduce the clearance between the presser
foot and the outside needle entry point.
＊
The front or rear inclination can be adjusted with
presser arm setscrew
.
(6) Position of the presser foot and the needle entry point
●
Upper knife type
Loosen setscrew
in the cloth cutting knife
installing base, adjust cloth cutting knife installing
base
to the left or right. Then fix the base.
●
Lower knife type
Loosen setscrews
in the knife base and adjust
knife base
to the left or right. Then fix the knife
base.
(7) Adjusting the knife dropping position
To Next Page
Loading...
Need help?
General
