23
ENGLISH
(4) Setting the number of stitches of the parallel section
Set the number of stitches from the parallel
section to the bottom section of eyelet.
Set the number of stitches with [RIGHT ] key
or [RIGHT ] key
.
1. The number of stitches can be set to
such an extent of 3 to 100 stitches. The
number of stitches that can be set is
limited by the set value of cut length.
Example) When the cut length is equal to
22 mm, the number of stitches is 6 to
41 stitches. In addition, if the number
of stitches is decreased, the number
of revolution of the sewing machine
automatically reduces.
2.
For T type, looper thread can be neatly
rolled in at the start of sewing by
increasing the number of stitches.
(5) Setting the number of stitches of the eyelet
Set the number of stitches of the top
section of eyelet.
Set the number of stitches with [RIGHT ] key
or [RIGHT ] key
.
The number of stitches can be set 4 to 20 stitches.
(6) Setting the cut space
Set the clearance where the knife drops
in the parallel section.
Set the cut space with [RIGHT ] key
or [RIGHT
] key
.
The space can be set
−
1.2 to 1.2 mm in the
increments of 0.1 mm.
Clearance
(7) Setting the eyelet space
Set the clearance where the knife drops
in the eyelet section.
Set the eyelet space with [RIGHT ] key
or
[RIGHT ] key
.
The space can be set
−
1.2 to 1.2 mm in the
increments of 0.1 mm.
Number of stitches
Clearance
Clearance
Number of
stitches
To Next Page
Loading...
Need help?
General
