2
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
2.29
RADIATOR INSPECTION / CLEANING
1. Check radiator air passages for restrictions or
damage.
2. Carefully straighten any bent radiator fins.
3. Remove any obstructions with compressed air or low
pressure water.
CAUTION
Washing the vehicle with a high-pressure washer could
damage the radiator fins and impair the radiators
effectiveness. Use of a high-pressure washer is not
recommended.
COOLANT DRAIN / FILL
1. Allow the vehicle to cool down if recently operated.
2. Remove the hood from the front cab.
WARNING
Escaping steam can cause burns. Never remove the
pressure cap while the engine is warm or hot. Always
allow the engine to cool before removing the pressure
cap.
3. Slowly remove the pressure cap to relieve any
cooling system pressure.
4. Place a drain pan under the lower radiator hose.
5. Slide the clamp back and remove the lower radiator
hose to drain the coolant from the radiator.
6. Allow the coolant to completely drain. Properly
dispose of the used coolant.
7. Reinstall coolant hose and reposition the spring
clamp.
8. Remove the pressure cap. Using a funnel, add the
recommended coolant to the top of the filler neck and
fill the recovery bottle to the MAX level.
9. Refer to “Cooling System Bleeding Procedure”
provided in Chapter 3.
FLUID CAPACITY
Recommended Coolant:Polaris Premium Pre-Mixed
Antifreeze
(PN 2871534) (Quart)(PN 2871323) (Gallon)
MAINTENANCE
To Next Page
Loading...
Need help?
General
