Quantum Scalar 1000 Reference Guide

Scalar DLC Reference Guide 161
Client Host Name Enter The host name of the computer running the client
software. ADIC recommends using the following:
• client host IP address
• client host DNS name, short
• client host DNS name, full
• localhost for the client operating from local host
(possible but not recommended because of security
reasons)
• any for the client operating from any host (possible
but not recommended because of security reasons)
Host alias Enter Host alias (ROBAR format).
Numeric system Select Numeric system format (decimal/hexadecimal).
Clean pool prefix Enter Clean pool prefix used by ROBAR client.
Dismount after clean Check Indicates whether the cleaning cartridge should be
dismounted after the cleaning ends.
Host is allowed to set
the time
Do not check A client host should not be allowed to set the time.
Notification sender
name
Enter Notification sender (ROBAR format).
Priority Select Low means the client-sent commands have the lowest
priority in a queue. Refer to Queue Tab
on page 174.
Medium means the client-sent commands have the
standard priority in a queue. Refer to Queue Tab
on
page 174.
High means the client-sent commands have the
highest priority in a queue. Refer to Queue Tab
on
page 174.
Sequence Do not check Commands sent by client without sequence option will
be executed as they’re ready. The system will not wait
until the previous client command is finished.
HCC Major Do not check Commands send by client without major host
parameter cannot be addressed/replied via the HCC/
MVS application.
Create Click Create client.
Cancel Click Cancel creation.
Help Click Open online help for the current pane.
Note
The new ROBAR Client is functional immediately after creation. No Scalar DLC service
restart is required.
Field/Button Icon Operation Description

Quantum Scalar 1000 Specifications

General

Brand	Quantum
Model	Scalar 1000
Category	Storage
Language	English