Scalar DLC Reference Guide 219
Cluster Configurator Tool
This tool should be used only for the Scalar DLC installed as a failover (cluster) solution.
Immediately after the Scalar DLC software is installed on both cluster nodes launch the cluster configurator
tool. It can be found on the Scalar DLC Installation CD with the following path:
Scalar_DLC\Cluster\SDLC_ClusterConfig.exe.
Figure 157 Cluster Configuration Utility: no configuration
Click Make SDLC Cluster Configuration to configure Scalar DLC software for a failover mode. When the
configuration is completed, the pop-up “Configuration created successfully“ window opens. Click OK to
return to the SDLC Cluster Configurator.
Figure 158 Cluster Configuration Utility: configuration complete
The Remove SDLC Cluster Configuration button should be used only
to re-configure Scalar DLC
software from failover (cluster) to basic (non-cluster) mode. If this is executed on a cluster, the Scalar DLC
failover solution will not function. However, the Scalar DLC itself will work in a basic mode (as if it has been
installed on standalone PC).
To Next Page
Loading...
Need help?
General