Scalar DLC Reference Guide 199
SNMP Tab
The SNMP tab displays current SNMP Service settings.
To install the missing SNMP service, use Control Panel > Add-Remove Windows Components >
Management and Monitoring Tools > Simple Network Management Protocol. Windows 2000 / 2003
system disk is required.
SNMP (Simple Network Management Protocol) is a network protocol used to manage TCP/IP networks. In
Windows, the SNMP service is used to provide status information about a host on a TCP/IP network.
The SNMP Tab provides the same service as the SNMP Service options (Windows Desktop > Start >
Settings > Control Panel > Administrative Tools > Services > SNMP Service Properties). It contains
three additional tabs with the following properties:
• Agents is used to configure the settings for SNMP agents. Refer to Agents
on page 200.
• Traps is used to configure the settings for SNMP traps. Refer to Traps
on page 201.
• Security is used to configure the settings for SNMP security. Refer to Security
on page 203.
IP address Supplied The IP address of the current cluster host.
Change
cluster node
Click Change active cluster node. The node that is currently active
goes down and the node currently passive goes up.
Note that this operation will be successful only when both
node PCs are running.
Help Click Open online help for the current pane.
Note
This tab is available only when the SNMP Agent service is successfully started on Scalar
DLC host PC.
Field/Button Icon Operation Description
To Next Page
Loading...
Need help?
General