Roland VS-2400CD User Manual

7—Project and Drive Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 103
RECOVER
To re-load VS-2400CD project backup data, use the RECOVER operation. When you
recover a project, the project is restored to your internal hard drive in its original state.
Recovering Backup Data
1. Hold down SHIFT and press F1 (PROJECT).
2. Insert the CD containing the backup into your CD-R/RW drive.
3. Select the drive containing the project backup data.
4. Press F6 (LIST) to view the drive’s contents. The VS-2400CD displays:
5. Press ENTER/YES to continue, or EXIT/NO to cancel the drive change.
6. Mark the project(s) you want to recover.
7. Turn the Time/Value dial to select the drive to which you want to recover the
marked backup data.
8. If “Recovr” isn’t visible above F2, press PAGE until it is.
9. Press F2 (Recovr)—the PROJECT RECOVER screen appears.
10. Set Erase all Projects to:
• Off —if you want to add the project(s) you’re recovering to the list of projects
already on the destination drive.
• On —if you want to clear the drive so it contains only your recovered projects.
11. Set the desired CD drive speed. Try MAX. If you experience problems recovering
the data, try a lower speed.
12. Press F5 (OK). The VS-2400CD asks if you want to save the currently loaded project.
13. Press ENTER/YES to save the loaded project before the recovery operation, or
press EXIT/NO to go straight to recovery.
The VS-2400CD asks if you’re sure you want to proceed with the recovery.
14. Press ENTER/YES to continue the recovery, or EXIT/NO to cancel.
15. If Erase All Projects is on, the VS-2400CD asks if you’re sure you want to erase the
destination drive first—press ENTER/YES to do so, or EXIT/NO to cancel recovery.
16. If the backup is larger than a single disk, the VS-2400CD asks for additional disks as
needed. Insert each requested disk in your drive and press ENTER/YES to proceed.
RECOVER is available only when the selected drive contains project backup data.
If the project is backed up on more than one disk, insert the first
disk containing backup data.
PROJECT menu
F2 (Recovr)
New drive’s
name
List of project
backup data
you’ve marked
Drive
containing
backup
Drive to which
data will be
recovered
Press F2 to scroll down
through the list of
project backup data if it
extends out of view, or
F1 (Scrol) to scroll up
through the list.
VS2400OMUS.book 103 ページ ２００６年２月２８日 火曜日 午前１１時１２分

Roland VS-2400CD Specifications

General

Brand	Roland
Model	VS-2400CD
Category	Musical Instrument
Language	English