7—Project and Drive Operations
94 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Amount of Recording Time with Each Recording Mode
This chart shows the number of minutes you’d get when recording a single track in a
single 10G partition. The available time depends on the selected sample rate.
Creating a New Project
1. Hold down SHIFT and press F1 (PROJECT).
2. If “NEW” isn’t visible above F2, press PAGE until it is.
3. Press F2 (NEW)—the PROJECT NEW screen appears.
4. Set the Copy System Prm parameter to:
•
Off
—to create a new project with default UTILITY menu parameter values
(UTILITY menu parameters are described in Chapter 27).
•
On
—to copy the current project-related UTILITY parameter values into the
new project.
5. Set the Copy Mixer/Scene Prm parameter to:
•
Off
—to create a new project with default mixer settings and no scenes.
•
On
—to copy the mixer settings and scenes from the currently loaded project
into the new project.
6. Select the desired sample rate and recording mode (Page 92).
7. Name the new project.
Mode: 96k 88.2k 64k 48k 44.1k 32k
M24 658 716 987 1,316 1,433 1,975
MTP 1,977 2,152 2,966 3,954 4,305 5,932
M16 988 1,076 1,483 1,977 2,152 2,966
CDR 988 1,076 1,483 1,977 2,152 2,966
MT1 1,977 2,152 2,966 3,954 4,305 5,932
MT2 2,635 2,866 3,953 5,271 5,732 7,907
LIV 3,163 3,442 4,744 6,326 6,885 9,489
LV2 3,954 4,304 5,932 7,909 8,609 11,864
Since scenes remember effect patch edits, copying scenes lets you move effect settings
from the current project into the new one you’re creating.
You can re-name the project later on—and add a comment, if you like—using the
project NAME operation (see Page 95).
PROJECT menu
F2 (NEW)
VS2400OMUS.book 94 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
