4—Setting Up and Basic Operations
78 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Turning Off the VS-2400CD
Turning Off the VS-2400CD
1. Hold down SHIFT, and press STOP•SHUTDOWN. The following dialog appears:
2. If you wish to turn off or restart the VS-2400CD, press ENTER/YES. If not, press
EXIT/NO to cancel the operation. If you press ENTER/YES, a dialog like this one
appears:
3. If you’ve made changes to the currently loaded project you’d like to preserve, press
ENTER/YES. If you haven’t, press EXIT/NO.
In either case, the VS-2400CD takes a few moments to prepare to shut down—and
to save your project if you pressed ENTER/YES in Step 3. When the VS-2400CD is
ready to be powered off, the following message appears:
4. If you’d like to restart the VS-2400CD, hold down SHIFT and press
PLAY•RESTART—the VS-2400CD begins its power-up sequence. If you’d like to
shut down the VS-2400CD, flip its rear-panel POWER switch to its Off position.
It’s important the you don’t simply flip the VS-2400CD’s POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you’d like to restart the VS-2400CD—perhaps while troubleshooting a problem—use
the procedure below as well.
If you’re shutting down the VS-2400CD when a factory demo song—or any other
protected project—is loaded, you won’t be prompted to store the current song.
If you need to move the VS-2400CD after shutting it down, wait 30 seconds or so to give
its hard drive a chance to stop spinning in order to avoid damaging it.
The name of the
currently loaded project.
The project’s sample rate and
recording mode (Page 93).
VS2400OMUS.book 78 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
