4—Setting Up and Basic Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 71
Each action is assigned a numbered
“Undo level.” The lower the number of the
level, the more recent the action. All
undoable actions in a project appear in
the Undo list along with the date and time
of each action.
Undoing a Track Recording or Editing Operation
1. Press UNDO•REDO.
2. Locate the desired action in the Undo list.
3. Turn the TIME VALUE dial to select the desired Undo
level—the selected level has an arrow to its left.
4. Press ENTER/YES. The selected action—and all other
recording and editing actions that took place after it—
is undone.
After the Undo operation is complete, the UNDO•REDO button remains lit to indicate
that you can cancel the Undo operation by performing a Redo.
Redo
If you change your mind about an action—or series of actions—you’ve undone, you can
perform a “Redo” while the UNDO•REDO button is lit. To do this, hold down SHIFT
and press UNDO•REDO. When the Redo dialog appears, press ENTER/YES.
Naming
You can assign names to a wide range of things in the VS-2400CD, such as:
• projects (Page 95) • tracks (Page 270) • takes (Page 259)
• phrases (Page 257) • effect patches (Page 219) • locators (Page 180)
• markers (Page 184) • scenes (Page 139) • routing templates (Page 282)
The pages in the previous list provide details about how to access each item’s naming
screen. The procedure you’ll use is the same no matter what it is you’re naming, and all
of the naming screens look alike, as in the following illustration.
When you undo a recording or editing operation, everything you did after the
operation originally took place is also undone.
Undo affects track recording and editing operations only—it doesn’t undo parameter
value changes.
If a project contains data required for undoing actions you’re sure you’ll never need to
undo, you can perform a project optimization to discard the unwanted data and reduce
the size of the project and the space it takes up on your hard disk. See Page 96.
You can set the UTILITY menu’s UNDO MESSAGE parameter so that when you press
UNDO, the VS-2400CD instantly reverses the last operation without displaying the
Undo list—see Page 358.
The ability to perform a Redo operation lasts only until you next save the project.
Oldest
Newest
Oldest
Newest
Fourth guitar solo take at 3:10 Undo Level 1
Third attempt at guitar solo at 3:08
Undo Level 2
Tried to record solo again at 3:05
Undo Level 3
Recorded guitar solo at 3:00
Undo Level 4
The
currently
selected
Undo level
VS2400OMUS.book 71 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
