9—Working with Input Signals
132 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Patching Input Connections
Connecting Input Signals to Input Channels
1. Go to the PATCH BAY or ROUTING VIEW screen (Page 130), and use
,
,
and/
or
to highlight the input channels to which you want to route your input signals.
2. Turn the Time/Value dial clockwise. With each tick of the dial, the next pair of
inputs—viewed from left to right—is routed to the selected input channels.
3. Turn the Time/Value dial to route the desired pair of inputs to the input channels.
4. To break the connection between an input pair and its input channels, turn the
Time/Value dial clockwise until no wires connect them.
We’ll use the PATCH BAY screen here for simplicity—you can also perform these steps
on the ROUTING VIEW screen, or use the CH EDIT P.BAY screen (Page 160).
You can route the same inputs to multiple pairs of input channels—this allows you to
create two different versions of a signal that you can use for different purposes.
We’ve selected
Input Channels
1 and 2.
(In this illustration,
we’ve cleared all
input-to-input channel
connections for visual
clarity.)
VS2400OMUS.book 132 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
