13—Operating the Hard Disk Recorder
Roland VS-2400CD Owner’s Manual www.RolandUS.com 187
Setting Auto Punch Points While a Project Is Playing
1. Start playback shortly before the location at which you want the punch to begin.
2. Hold down A.PUNCH.
3. Without releasing A.PUNCH, press TAP at the desired punch-in point.
4. Continue holding A.PUNCH and press TAP at the desired punch-out location.
5. Release A.PUNCH.
Clearing Auto Punch Points
1. Hold down A.PUNCH.
2. Without releasing A.PUNCH, hold down CLEAR and press IN or OUT.
3. Release A.PUNCH.
Setting Auto Punch Points Using Locators
You can learn about locators on Page 179. The following steps presume you’ve already
placed locators at the desired punch-in and -out locations.
1. Press LOCATOR—so it’s lit—and select the locator bank containing the locators
you want to use as punch-in and punch-out points.
2. Press the locator positioned at the start of the section you want to punch.
3. Hold down A.PUNCH and press IN.
4. Press the locator positioned at the end of the section you want to punch.
5. Hold down A.PUNCH and press OUT.
Setting Auto Punch Points Using Markers
Markers are described on Page 182. Before setting your Auto Punch In and OUT points,
place markers at the desired punch-in and -out locations.
1. Move to the marker located at the desired punch-in location.
2. Hold down A.PUNCH and press IN.
3. Move to the marker positioned at the end of the section you want to punch.
4. Hold down A.PUNCH and press OUT.
Editing Auto Punch IN and OUT Points Manually
You can edit, clear and place Auto Punch IN and OUT points on the AUTO PUNCH/
LOOP screen in the UTILITY MENU.
1. Hold down SHIFT and press A.PUNCH to view the AUTO PUNCH/LOOP screen.
You can do a few things with your Auto Punch IN and OUT points on this screen:
• You can use the cursor buttons and Time/Value dial, or your mouse, to change
either point’s location by time code or measures and beats.
• You can select IN or OUT on the screen and press F2 (CLEAR) to erase its
current time assignment.
Auto Punch IN time
Auto Punch OUT time
VS2400OMUS.book 187 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
