25—Automix
326 www.RolandUS.com Roland VS-2400CD Owner’s Manual
INSERT
Insert adds an area of blank space at the IN location equal to the length of the selected
Automix region—all data at the IN point and onward is moved so that it starts at the
end of the inserted blank space. When you’ve inserted empty space in an audio track,
you’ll want to insert space in the accompanying Automix track as well so that your
Automix events line up properly with their corresponding audio data.
CUT
CUT deletes the Automix events between the IN and OUT points and moves the
remaining data forward so that it starts at the IN point. You might cut Automix data
when it occurs just a bit later than you want it to, or when you need to re-align it with
audio you’ve moved forward in the project.
ERASE
Automix ERASE cleans out Automix events between the IN and OUT points. This can
be useful when you’ve recorded parameter value changes you decide you don’t want,
preferring to let an earlier parameter value remain in place until the OUT point.
COMP/EXP.
The Automix COMP/EXP. (“COMPRESS/EXPAND) edit operations allow you to lower
or raise parameter values in the selected region. COMP/EXP. actually contains three
separate operations:
•
Compression and Expansion
—change parameter values according to their distance
from a specified threshold value (“T” stands for “Threshold” in the illustrations
below). Use compression to make value changes in the selected Automix data
Edit point: What it does:
FROM sets the location of the Automix data region’s time anchor
TO sets the destination location for the time anchor
When you move Automix data to a new location, it replaces any Automix data already
present in the destination location.
Before After
OUTIN
OUTIN
Before After
OUTIN OUTIN
VS2400OMUS.book 326 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
Need help?
General
