Tool offsets
7.7 Free assignment of D numbers, cutting edge numbers
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
433
Significance
Dno
D number for which the T number shall be searched.
Tno
T number found
Value: Significance:
0 The T number has been found. Tno contains the value of the T
number.
-1 No T number exists for the specified D number; Tno=0.
-2 The D number is not absolute. Tno receives the value of the first
found tool, that contains the D number with the value Dno.
status
-5 The function was not able to be executed for another reason.
7.7.5 Free assignment of D numbers: Invalidate D numbers (DZERO)
Function
The DZERO command is used for support during retooling. Compensation data sets tagged
with this command are no longer verified by the
CHKDNO command. These data sets can be
accessed again by setting the D number once more with
SETDNO.
Syntax
DZERO
Significance
DZERO
Marks all D numbers of the TO unit as invalid.
To Next Page
Loading...
Need help?
General
