Siemens SINUMERIK 828D Programming Manual

Tool offsets
7.2 Additive offsets
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
395
7.2.3 Delete additive offsets (DELDL)
Function
The DELDL command deletes the additive offsets for the cutting edge of a tool (to release
memory space). Both the defined wear values and the setup values are deleted.
Syntax
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<Status>=DELDL[<t>,<d>]
Significance
DELDL
Command to delete additive offsets
<t>
T number of the tool
<d>
D number of the tool cutting edge
DELDL[<t>,<d>]
All additive offsets of the cutting edges
<d> of the tool <t> are
deleted.
DELDL[<t>]
All additive offsets of all cutting edges of tool
<t> are deleted.
DELDL
All additive offsets of all cutting edges of all tools of the TO unit are
deleted (for the channel in which the command is programmed).
Delete status
Value: Significance:
0 Deletion was successfully completed.
<status>
- Offsets have not been deleted (if the parameter settings
specify exactly one tool edge), or not deleted completely (if
the parameter settings specify several cutting edges).
Note
Wear and setting-up values of active tools cannot be deleted (essentially the same as the
delete behavior of
D or tool data).

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English