Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
549
Motion synchronous actions
10
10.1 Basics
Function
Synchronized actions allow actions to be executed such that they are synchronized to
machining blocks.
The time at which the actions are executed can be defined by conditions. The conditions are
monitored in the interpolation cycle. The actions are therefore responses to real-time events,
their execution is not limited by block boundaries.
A synchronized action also contains information about its service life and about the
frequency with which the programmed main run variables are scanned and therefore about
the frequency with which the actions are started. In this way, an action can be triggered just
once or cyclically in interpolation cycles.
Possible applications
6HUYRYDOXHV
3RO\QRPLDOFFKDQJHG
0+IXQFWLRQLVVXHG
$FWLYDWHFRXSOLQJ
0HDVXULQJ
1&IXQFWLRQV
$FWLRQV&RQGLWLRQV
1&IXQFWLRQV
6SHHGV
3RVLWLRQV
1&.RXWSXWV
0DUNHU
3DUDPHWHU
3RO\QRPLDO
FRHIILFLHQWV
$FWXDOYDOXHV
6HWSRLQWV
1&.LQSXWV
*DWLQJORJLF
6\QFKURQL]HGDFWLRQV
5HDOWLPHSURFHVVLQJ
3UHSDUHGEORFNV
%ORFNSUHSDUDWLRQ
3DUWSURJUDP
● Optimizing runtime-critical applications (e.g. a tool change)
● Fast response to an external event
● Programming AC controls
● Setting up safety functions
● ....
To Next Page
Loading...
Need help?
General
