Siemens SITOP PSU8600 User Manual

Engineering and remote access
7.4 SIMATIC STEP 7 in the TIA Portal
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
191
●
Activate web server on this module
Define as to whether the device may be accessed via the web server. You can find more
information about the web server in Chapter "Web server (Page 270)".
●
Enable automatic logoff
Define whether a user should be automatically logged off after closing the web server.
●
Permit access only with HTTPS
Define whether access is only permissible with HTTPS.
●
Enable automatic update
When you enable "Automatic update" then the actual values of the SITOP PSU8600 and
connected supplementary modules are sent to the web server.
●
Update interval
Define the interval in which the actual values are sent to the web server.
7.4.5.3
Parameterizing output 1
The procedure is the same for all parameters. The individual parameters and their possible
values are described in the following sections.
Preconditions
● The SITOP PSU8600 was integrated in the opened project.
● When configuring an expansion module, this must be assigned to the SITOP PSU8600.
Procedure
1. Select the SITOP PSU8600 or the expansion module in the Device view.
2. In the inspector window in the navigation area, open the range of the required output.
3. You can see the possible subgroups for parameterization.
Parameter output 1
Parameter
Value range
Default setting
Switch on output
Yes/no
No
Setpoint output voltage
4 - 28 V
24.0 V
Response threshold of the output current
2 - 20 A or 4 - 40 A
20 A or 40 A
Prewarning threshold output current 0 - 100 % 90 %
On delay Dependent on the settings in
the basic unit
None
Operating mode ELECTRONIC
SHUTDOWN / CONSTANT
CURRENT
ELECTRONIC
SHUTDOWN

Siemens SITOP PSU8600 Specifications

General

Brand	Siemens
Model	SITOP PSU8600
Category	Power Supply
Language	English