Engineering and remote access
7.7 Web server
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
277
Here, in the following areas you can make changes:
● Changing the web server settings, see Chapter "Web server (Page 288)"
● Configuring the OPC UA interface, see Chapter "OPC UA server (Page 289)"
● Configuring the NTP service, see Chapter "NTP client (Page 290)".
● Configuring the PROFINET interface, see Chapter "Configuring the PROFINET interface
(Page 287)"
● User administration, see Chapter "PROFINET security (Page 290)"
● Carry out a system synchronization, see Chapter "System synchronization (Page 286)"
● Configuring the SITOP PSU8600 basic unit and the expansion modules, see Chapter
"Configuring SITOP PSU8600 (Page 292)"
Further, you can save the configurations and load the existing configurations into the device,
see Chapter "Loading and saving device configuration (Page 303)".
Loading the configuration (commissioning)
You download the actual configuration from the web server directly to the device using the
"Download to device" button.
Procedure for saving the configuration
1. Click on the "OK" button to load the configuration.
2. Acknowledge the confirmation prompt.
To Next Page
Loading...
Need help?
General
