Addendum
14-20 Xerox 4112/4127 Copier/Printer
User Guide
4. If the UI indicates there is a jam in the digital press, follow the instructions on the screen to
remove any paper in the area indicates. Refer to the Jam Clearance section in the Problem
Solving chapter in this manual.
5. Follow the instructions displayed on the digital press UI to resume printing.
Basic troubleshooting
When a problem occurs with your Interface Module, instructions may appear on the UI; refer to
the information in this section to help resolve the problem.
The fault code table, which starts on the following page, lists problems and suggested solutions
that apply to the Interface Module. If the problem persists after following all instructions, call
your Xerox representative.
Fault Codes
Fault code Possible cause Recommended solution
048 100
048 102
048 103
048 900
048 901
048 903
Paper jam
A jam occurred during
feeding
A jam notification is
displayed on the UI
Open the front door.
Carefully remove all sheets and paper scraps from jam
clearance areas.
Close the front door.
Verify the paper used is within the approved paper
specifications.
048 300 The front door is open. Close the front door.
048 310
048 311
048 312
048 313
048 314
048 315
048 316
Decurler sensor or belt
problem
Power off, then power on
048 318
048 319
Cooling fan failure Power off, then power on
048 320
048 321
048 322
Communication failure or
connection failure
Check the connection between Interface Module and the
finishing device.
Power off, then power on.
048 323 Interface Module failure Power off, then power on
To Next Page
Loading...
Need help?
General
