Xerox 4112 User Manual

Addendum
14-24 Xerox 4112/4127 Copier/Printer
User Guide
Sample Print feature
Sample prints can be printed by performing the following steps:
1. From the [Copy Output] feature, select:
a. Collated or Uncollated and
b. Output Destination/Offset Stacker
2. Select [Stacker - Stacker Cart] then [Real Time Sample Job].
3. Select [Sample Job On].
The [Sample Job On] feature delivers specific pages or sets of an output job to the High
Capacity Stacker’s Top Tray. The Sample Job allows the user to check the output while
continuing to deliver the major portion of the job to the Stacker Cart.
•For Collated output, for example, if the output is 100 sets of a 50-page original document,
the user can choose 1-3 output sample sets.
•For Uncollated output, for example, if the output is 100 copies of each page of a 50-page
original document, the user can choose 1-3 sample pages
4. Enter the desired Sample pages/sets to print for the [First Sample] and then for the [Second
Sample] and [Third Sample] (if applicable).
5. Select [Save].
Unloading the Stacker Tray
Use the following procedure to unload the Stacker Tray when it is full, or to retrieve a completed
job:
1. Press the Unload button on the HCS Control Panel. The Wait light blinks until the Stacker
Tray has reached the down position.
2. Open the front door when the Unload Light illuminates.
3. Position the securing bar on top of the stacked paper.
4. Pull the Stacker Cart straight out. Remove the securing bar.
5. Remove the paper from the Stacker Tray.
6. Push the empty Stacker Cart straight into the HCS.
7. Position the securing bar on the fixed area inside the HCS.
8. Close the door. The tray will rise to the operate position.
Unload button

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English