Name: Yamaha 01V96
Brand: Yamaha
Rating: 4 (1 reviews)

To Next Page

To Previous Page

120 Chapter 9—Aux Outs

01V96 Version 2—Owner’s Manual

Copying Channel Fader Positions to Aux Sends

While Aux Sends are in Variable mode, you can copy all Input Channel fader positions on

one layer to the corresponding Aux Sends.

This is convenient when you wish to send to the musicians monitor signals that have the

same balance setting as the Stereo Out signals.

1 Press and hold down the copy source layer (LAYER [1–16] or [17–32]) button.

2 Press one of the FADER MODE [AUX 1]–[AUX 8] buttons to select the desired

Aux Send copy destination.

The conﬁrmation window for the Copy operation appears.

3To execute the Copy operation, move the cursor to the YES button, then

press [ENTER].

To cancel the Copy operation, move the cursor to the NO button, then press [ENTER].

Note: If you release the button in the LAYER section before you proceed to Step 2, you will be

unable to complete the Copy operation.

Tip: If the copy destination Input Channel has been paired with a vertical partner in another

Layer, the fader position will be copied to the partner’s Aux Send.

Other manuals for Yamaha 01V96

Questions and Answers:

Need help?

Do you have a question about the Yamaha 01V96 and is the answer not in the manual?

General