170 Chapter 15—Scene Memories
01V96 Version 2—Owner’s Manual
Fading Scenes
You can specify the time it takes the Input and Output Channel faders (or level controls) to
move to their new positions when a Scene is recalled. This is called Fade Time, and it can be
set for each channel in the range of 00.0 through 30.0 seconds (in 0.1 second steps). You can
set the Fade Time for each Scene individually or for all Scenes globally.
Fading Input Channels
To set the Fade Time for Input Channels 1–32 and ST IN Channels 1–4, press the DISPLAY
ACCESS [SCENE] button repeatedly until the Scene | In Fade page appears. Move the cur-
sor to the desired channel parameter box, then rotate the Parameter wheel or press the
[INC]/[DEC] buttons to modify the Fade Time setting.
A Global Fade Time
When this check box is checked, a Scene is recalled using the currently-specified Fade
Time. (The Fade Time setting stored in the recalled Scene is temporarily ignored.) This
check box setting works in unison with the Out Fade page.
B ALL INPUT CLEAR
This button resets all channel Fade Times on the page to 00.0 second.
C INPUT CH1–32/ST IN 1–4
These parameters enable you to set the Fade Time for each Input Channel in the range
of 00.0 through 30.0 seconds. The Fade Time setting for one channel in a pair works in
unison with its partner.
Tip:
•If you operate a fader while fading channels, the fader’s Fade Time setting is temporarily
ignored.
•You can copy the currently-selected Input Channel Fade Time to all Input Channels by dou-
ble-clicking the [ENTER] button to display a window for copying. This is convenient when
you wish to set the Fade Time for all channels simultaneously.
1
3
2
To Next Page
Loading...
Need help?
General
