MIDI 215
01V96 Version 2—Owner’s Manual
MIDI
18
18 MIDI
This chapter describes the 01V96’s MIDI-related functions.
MIDI & the 01V96
Using Control Changes, Program Changes, and other MIDI messages enables you to recall
Scenes and edit parameters on the 01V96, and store 01V96 internal data on external MIDI
devices.
The 01V96 supports the following MIDI messages. Each of these MIDI messages can be
individually turned on or off for transmission and reception.
• Program Changes
If you assign the 01V96’s Scenes to Program Change numbers, the 01V96 transmits Pro-
gram Changes when it recalls Scenes. Also, the 01V96 will switch Scenes when it receives
Program Changes.
• Control Changes
If you assign the 01V96’s parameters to Control Change numbers, the 01V96 transmits the
assigned Control Changes when the parameter values change. Also, the 01V96 changes cer-
tain parameter values when it receives the corresponding Control Changes.
• System Exclusive Messages
The 01V96 transmits System Exclusive Parameter Changes in real-time when the parameter
values change. Also, the 01V96 notifies certain parameter values when it receives assigned
Parameter Changes.
• MMC (MIDI Machine Control)
MMC is used for external machine control.
• MIDI Note On/Off
These messages are used to adjust the Freeze effect.
• Bulk Dump Messages
These messages enable you to store the 01V96’s internal data to a sequencer or MIDI filer.
When the 01V96 receives these messages, they overwrite the 01V96 data
The 01V96 features the following interface for transmitting and receiving MIDI data.
• MIDI IN/THRU/OUT ports
These ports transmit and receive MIDI data to and from standard MIDI devices. Each port
is a single port interface that transmits and receives single-port data (16 channels x 1 ports).
The MIDI THRU port outputs MIDI messages received at the MIDI IN port without mod-
ification (as is).
• USB port
This port is used to connect a computer and transfer MIDI messages. This is a multiport
interface that transmits and receives up to eight-port data (16 channels x 8 ports). If you
connect a computer to the USB port, you must install the appropriate driver software on
the computer. See the Studio Manager Installation Guide for more information on install-
ing drivers.
Note: If the computer is turned on but the USB MIDI application has not been launched,
01V96 performance may be slow. In this case, cancel the assignment of the USB port as the
MIDI message transmission port.
To Next Page
Loading...
Need help?
General
