ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
130 Confidential and Proprietary Information of ZTE CORPORATION
For the configuration of Global ACL, perform the following steps.
1. To enter into Global ACL configuration, use command
config acl global in global configuration mode. This is
shown in
Table 196.
TABLE 196 CONFIG ACL GLOBAL COMMAND
Format Mode Function
config acl global global config This enters into
Global ACL
configuration mode
Result: This enters into Global ACL configuration mode.
2. To configure ACL rules, use command rule <rule-id>
{permit|deny} port [<port-id> | any ] {< ip-protocol> |
ip | tcp | udp| arp| any}{<source-ipaddr wildcard>|any}
[<source-port sourceport-mask>]{<destination-ipaddr
wildcard>|any} [<dest-port destport-mask>][dscp]
[fragment] [ether-type <proto-number>] [cos][<source-
vlanId>] [<source-mac wildcard >| any] [<destination-mac
wildcard>| any] in ACL config mode. This is shown in
Table 197.
TABLE 197 RULE COMMAND
Format Mode Function
rule <rule-id>
{permit|deny} port
[<port-id> | any ] {<
ip-protocol> | ip | tcp
| udp| arp|
any}{<source-ipaddr
wildcard>|any}
[<source-port
sourceport-
mask>]{<destination-
ipaddr wildcard>|any}
[<dest-port destport-
mask>][dscp]
[fragment] [ether-
type <proto-
number>]
[cos][<source-
vlanId>] [<source-
mac wildcard >| any]
[<destination-mac
wildcard>| any]
ACL config
This configures
ACL rules
Result: This configures ACL rules.
E
ND OF STEPS
Global ACL has been configured.
Steps
Result
To Next Page
Loading...
Need help?
General