Zte ZXR10 2920 User Manual

Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 181
It is necessary to operate Service Provider Network after
Customer Port configuration. Packets can be exchanged
successfully. Configure all ports in Service Provider Network as
Tag Ports and all Customer Ports as Untag Ports.
All the packets exchanged in Service Provider Network carry two
layers of Tag which are Uplink Tag and Customer Tag. When
packets leaving Service Provider Network, there is only one
layer of Tag left: Customer Tag.
Configuring SQinQ
This topic describes the configuration of SQinQ strategy policy.
For the configuration of SQinQ, perform the following steps.
1. To configure SQinQ session, use command set sqinq-
session <1-256> customer-vlan <vlanlist> uplink-vlan
<1-4094> in global configuration mode. This is shown in
Table 293.
TABLE 293 SET SQINQ SESSION COMMAND
Format Mode Function
set sqinq-session
<1-256>
customer-vlan
<vlanlist> uplink-
vlan <1-4094>
global config This configures
SQinQ session
Result: This configures SQinQ session.
2. To set Qos remark, use command set policy qos-
remark in sqinq-session <1-256> profile <0-71> up
{no-change|enable-modify|disable-modify} dscp {no-
change|enable-modify |disable-modify} in global
configuration mode. This is shown in
Table 294.
TABLE 294 QOS REMARK IN SQINQ COMMAND
Format Mode Function
qos-remark in
sqinq-session <1-
256> profile <0-
71> up {no-
change|enable-
modify|disable-
modify} dscp
{no-
change|enable-
modify |disable-
modify}
global config This sets Qos
remark
Result: This sets Qos remark.
Service
Provider Vlan
Configuration
Purpose
Steps

Zte ZXR10 2920 Specifications

General

Brand	Zte
Model	ZXR10 2920
Category	Switch
Language	English