Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
296 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 441 SET LOOP DETECT PORT PROTECT COMMAND
Format Mode Function
set loopdetect
port <portlist>
protect
{enable|disable}
global config This enable/disable
loop test protection
function of specified
port
Result: This enable/disable loop test protection function of
specified port
Note: Loop test protection function means that port is
automatically blocked when it detects a loop. In this way,
influence caused by port loop is avoided.
6. To enable/disable loop test protection function of a trunk,
use command set loopdetect trunk <trunklist> protect
{enable|disable} in global config mode. This is shown in
Table 442.
TABLE 442 SET LOOP DETECT TRUNK PROTECT COMMAND
Format Mode Function
set loopdetect
trunk <trunklist>
protect
{enable|disable}
global config This enable/disable
loop test protection
function of a trunk
Result: This enable/disable loop test protection function of a
trunk.
7. To set time for blocking port with loop, use command set
loopdetect blockdelay <1-1080> in global config mode.
This is shown in
Table 443.
TABLE 443 SET LOOP DETECT BLOCK DELAY COMMAND
Format Mode Function
set loopdetect
blockdelay <1-
1080>
global config This set time for
blocking port with
loop
Result: This set time for blocking port with loop.
Note: Time for blocking port with loop refers to time for
blocking port when a loop is detected, that is, port
protection time. Protection takes effect only when loop test
protection function of port is enabled.
8. To set interval time of sending loop test packet, use
command set loopdetect sendpktinterval <5-60> in
global config mode. This is shown in
Table 444.

Zte ZXR10 2920 Specifications

General

Brand	Zte
Model	ZXR10 2920
Category	Switch
Language	English