Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 243
FIGURE 43 SWITCH ROLE CHANGEOVER RULE
Command switch
Candidate switch
Member switch
Independent
switch
Specified as a command switch
Specified as a candidate switch
(without member)
Specified as an
independent switch
Add to the cluster
Delete from the cluster
Specified as a candidate switch
Specified as an independent switch
(without member)
Specified as a command switch
Specified as a command switch
Configuring a ZDP
This topic describes ZDP configuration. ZDP (Discovery
Protocol) is a protocol used to discover the related information
about direct neighbor node, including adjacent device ID,
device type, version and port information. This protocol
supports the refreshing and aging of neighbor device information
table.
To configure cluster management function, meet the following
requirement.
îš„ To configure cluster management function, use command
config group to enter into cluster management
configuration mode.
For the configuration of ZDP, perform the following steps.
1. To enable/disable ZDP function, use command set zdp
{enable|disable} in group config mode. This is shown in
Table 392.
TABLE 392 SET ZDP COMMAND
Format Mode Function
set zdp
{enable|disable}
group config This enable/disable
ZDP function
Result: This enable/disable ZDP function.
Note: By default, system ZDP function is enabled. When
system ZDP function is disabled, contents of neighbor device
information table are cleared, and ZDP packets processing is
suspended.
Purpose
Prerequisite
Steps
To Next Page
Loading...
Need help?
General