Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
150 Confidential and Proprietary Information of ZTE CORPORATION
Configuring 802. 1x Transparent
Transmission
This topic describes the configuration of 802. 1x transparent
transmission in ZXR10 2920/2928/2952.
For configuration of 802. 1x transparent transmission, perform
the following steps.
1. To enable/disable the 802. 1x transparent transmission
function, use command set 802. 1xrelay
{enable|disable} in global configuration mode. This is
shown in
Table 241.
TABLE 241 SET 802. 1X RELAY COMMAND
Format Mode Function
set 802. 1xrelay
{enable|disable}
global config This enable/disable
the 802. 1x
transparent
transmission
function
Result: This enable/disable the 802. 1x transparent
transmission function.
2. To display the configuration of 802. 1x transparent
transmission, use command show 802. 1xrelay in global
configuration mode. This is shown in
Table 242.
TABLE 242 SHOW 802. 1X RELAY COMMAND
Format Mode Function
show 802.
1xrelay
global config This displays the
configuration of
802. 1x
transparent
transmission
Result: This displays the configuration of 802. 1x
transparent transmission.
E
ND OF STEPS
802. 1 x transparent transmissions in ZXR10
2920/2928/2952have been configured.
Layer 3 Configuration
ZXR10 2920/2928/2952 provides few layer 3 functions for the
remote configuration and management. To realize the remote
access, an IP port must be configured on the switch. If the IP
Purpose
Steps
Result
Introduction to
Layer 3

Zte ZXR10 2920 Specifications

General

Brand	Zte
Model	ZXR10 2920
Category	Switch
Language	English