Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
250 Confidential and Proprietary Information of ZTE CORPORATION
member switch cannot change itself to a candidate switch
or command switch.
f In setting command switch, VLAN to which the layer 3
port is bound shall be the specified VLAN for collecting
topology information. Once a switch is configured to be
a command switch, specified VLAN for collecting
topology information cannot be changed.
f Command switch is allowed to be a candidate switch or
independent switch only when the cluster has no member
switch.
E
ND OF STEPS
Cluster management Unique ID of cluster has been configured.
Configuring a Cluster Member
This topic describes the configuration of cluster member to
add/delete.
For the configuration of cluster member, perform the following
steps.
1. To add a member based on device MAC address, use
command set group add mac <xx. xx. xx> in group
config mode. This is shown in
Table 410.
TABLE 410 SET GROUP ADD MAC COMMAND
Format Mode Function
set group add
mac <xx. xx.
xx>
group config This adds a
member based on
device MAC address
Result: This adds a membe based on device MAC address.
2. To add a member based on device MAC address and
specify member ID, use command set group add mac <xx.
xx. xx> <1-255> in group config mode. This is shown in
Table 411.
TABLE 411 SET GROUP ADD MAC COMMAND
Format Mode Function
set group add
mac <xx. xx.
xx> <1-255>
group config This adds a
member based on
device MAC address
and specify member
ID
Result: This adds a member based on device MAC address
and specify member ID.
Result
Purpose
Steps

Zte ZXR10 2920 Specifications

General

Brand	Zte
Model	ZXR10 2920
Category	Switch
Language	English