Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 253
TABLE 418 SET GROUP TFTPSVR COMMAND
Format Mode Function
set group tftpsvr
< A. B. C. D >
group config This sets IP address
of internal public
TFTP Server of
cluster
Result: This sets IP address of internal public TFTP Server of
cluster.
E
ND OF STEPS
Cluster parameters have been configured.
Above parameters can be configured for command switch only.
Effective holding time of cluster means that when command
switch detects communication failure of a member switch (or a
member switch detects that of command switch), and
communication is recovered within effective holding time,
member status is normal; if the communication is not recovered
after effective holding time, command switch displays that
member is in DOWN state. After communication is recovered,
member is added to cluster automatically and is displayed in UP
status.
If IP address of TFTP Server of cluster is configured, member
switch can access TFTP Server by directly accessing command
switch.
Configuring Access and Control
Cluster Members
This topic describes the configuration of access and control
cluster members.
For the configuration of access and control cluster members,
perform the following steps.
1. To switch from command switch to a specified member
switch, use command rlogin member <1-255> in
privileged mode. This is shown in
Table 419.
TABLE 419 RLOGIN MEMBER COMMAND
Format Mode Function
rlogin member
<1-255>
privileged mode This switches from
command switch to
a specified member
switch
Result: This switches from command switch to a specified
member switch.
Result
Note:
Purpose
Steps
To Next Page
Loading...
Need help?
General