Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
46 Confidential and Proprietary Information of ZTE CORPORATION
For the configuration of online command help, perform the
following steps.
1. Input ? behind the prompt of any command mode to view all
commands and brief descriptions of this mode.
Result: Command mode is viewed.
Example: An example given below shows ? behind the
prompt of the command mode.
zte>?
enable enable configure mode
exit exit from user mode
help description of the interactive
help system
show show config information
list print command list
zte>
2. Input the question mark behind a character or character
string.
Result: This will view the list of commands or keywords
beginning with that character or character string.
Example: An example given below shows the character
string.
zte(cfg)#c?
config clear create
zte(cfg)#c
3. Input ? behind the command, keyword and parameter.
Result: It shows the keyword or parameter to be input next
and its brief explanation.
Example: An example is given below.
zte(cfg)#config ?
snmp enter SNMP config mode
router enter router config mode
tffs enter file system config mode
nas enter nas config mode
group enter group management config mode
acl enter acl config mode
zte(cfg)#config
4. If a wrong command, keyword or parameter is entered then
press Enter.
Result: It will show message “Command not found” will be
displayed on the interface.
Example: An example is given below:
Steps

Zte ZXR10 2920 Specifications

General

Jumbo Frame	9K Bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Power Supply	AC 100-240V, 50/60Hz
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Category	Switch